Adding A Policy - HP 1920 Gigabit Ethernet Switch Series User Manual

Item
Filter

Adding a policy

1. Select QoS > QoS Policy from the navigation tree.
2. Click the Add tab to enter the page for adding a policy.
Figure 468 Adding a policy
3. Add a policy as described in
4. Click Add.
Description
CIR Set the committed information rate (CIR), the average traffic rate.
Set the committed burst size (CBS), number of bytes that can be sent in
CBS each interval. This function is not supported in the current software
version, and it is reserved for future support.
Set the action to perform for exceeding packets.
Discard
After selecting the Red box, you can select one of the following options:
•
Red
•
Pass
This function is not supported in the current software version, and it is
reserved for future support.
Configure the packet filtering action.
After selecting the Filter box, select one item in the following list:
•
•
•
Table
Discard—Drops the exceeding packet.
Pass—Permits the exceeding packet to pass through.
Permit—Forwards the packet.
Deny—Drops the packet.
Not Set—Cancels the packet filtering action.
156.
483