Initialize; Ipsetup - HP 1920 Gigabit Ethernet Switch Series User Manual

initialize

Syntax
initialize
Parameters
None
Description
Use initialize to delete the configuration file to be used at the next startup and reboot the device with the
default configuration being used during reboot.
Use the command with caution because this command deletes the configuration file to be used at the
next startup and restores the factory default settings.
Examples
# Delete the configuration file to be used at the next startup and reboot the device with the default
configuration being used during reboot.
<Sysname> initialize
The startup configuration file will be deleted and the system will be rebooted.Continue?
[Y/N]:y
Please wait...

ipsetup

Syntax
ipsetup { dhcp | ip-address ip-address { mask | mask-length } [ default-gateway ip-address ] }
Parameters
dhcp: Specifies the interface to obtain an IPv4 address through DHCP.
ip-address ip-address: Specifies an IPv4 address for VLAN-interface 1 in dotted decimal notation.
mask: Subnet mask in dotted decimal notation.
mask-length: Subnet mask length, the number of consecutive ones in the mask, in the range of 0 to 32.
default-gateway ip-address: Specifies the IPv4 address of the default gateway. With this argument and
keyword combination configured, the command not only assigns an IPv4 address to the interface, but
also specifies a default route for the device.
Description
Use ipsetup dhcp to specify VLAN-interface 1 to obtain an IPv4 address through DHCP.
Use ipsetup ip address ip-address { mask | mask-length } to assign an IPv4 address to VLAN-interface 1.
By default, the device automatically obtains its IPv4 address through DHCP; if fails, it uses the assigned
IP address.
If there is no VLAN-interface 1, either command creates VLAN-interface 1 first, and then specifies its IPv4
address.
Examples
# Create VLAN-interface 1 and specify the interface to obtain an IPv4 address through DHCP.
<Sysname> ipsetup dhcp
25