Nikon D200 Repair Manual page 85

DG-PCB unit
・ Solder the GND line on G-side of the DG-PCB (#B1017). (There are "S" and "G" letters on the
DG-PCB)
・ Solder each shield wire on A, B, C, and D. (ref. Fig)
・ Mount the DG-PCB unit (#B1017).
・ Solder the four shield wires. (ref. Fig. )
・ Connect two harnesses to the connector.
・ Put the ferrite core in the CCD FPC.
・ Connect the four FPCs to the con-
nectors.
・ Attach the tape (#926).
・ Put the shield wires under the
viewfi nder for arrangement.
#926
Harness
Core line (coated)
ＧＮＤ側
GND
Fig.
1040
Harness
- Ａ45 ･
C
１１２７
×2
D
Tape (#926)
#B1017 (DG-PCB unit)
-
INC
VBA13001-R.3677.A
A
B