Configuring An Ftp Server To Store Snapshots; Configuring A Remote Alarm Host; Configuring Multicast - Interlogix TruVision DVR 12 User Manual

Before configuring this function, you must first install the SNMP software.
To configure SNMP protocol settings:
1. From the menu toolbar, click
2. Enter the required settings.
3. Click to save the settings.
Apply
Configuring an FTP server to store
snapshots
You can upload your snapshots to an FTP server for storage.
Note: It is not possible to stream video to an FTP site.
To configure the FTP server settings:
1. Click the
Network Settings
2. Click and check the
FTP
3. Enter the FTP server information.
4. Click Apply.

Configuring a remote alarm host

If a remote alarm host set, the DVR sends a signal to the host when an alarm is
triggered. The remote alarm host must have the TruVision Navigator server
software installed.
To set up a remote alarm host:
1. From the menu toolbar, click
2. Enter Alarm Host IP and Alarm Host Port.
Alarm host IP represents the IP of the remote PC where the Network Video
Surveillance software installed. The alarm host port value must be the same
as software's alarm monitor port. Default port is 7200.
3. Click to save the settings.
Apply

Configuring multicast

Setting up multicasting resolves limitation issues when streaming videos through
a network access device. A multicast address spans the Class-D IP range of
224.0.0.0 to 239.255.255.255. We recommend that the IP address range of
239.252.0.0 to 239.255.255.255 be used.
TruVision DVR 12 User Manual
Network Settings
icon in the menu toolbar.
box.
Enable FTP
Network Settings
Chapter 6: Network settings
>
SNMP.
>
More Settings.
39