Checking Hdd Status; Configuring Hdd Alarms; Checking The S.m.a.r.t. Information - Interlogix TruVision DVR 12 User Manual

Checking HDD status

You can check the status of any of the installed HDDs on the DVR at anytime.
To check the status of a HDD:
1. From the menu toolbar, click
2. Note the status of the HDDs listed under the Status column.
If the status is listed as Normal or Sleeping, the HDD is in working order. If it
is listed as Abnormal and has already been initialized, the HDD needs to be
replaced. If the HDD is Uninitialized, you need to initialize it before it can be
used in the DVR. Refer to "Initializing HDDs" on page 43 for more information.
Note: This information is also available under
Information > HDD

Configuring HDD alarms

HDD alarms can be set to trigger when an HDD is uninitialized or in an abnormal
state.
To set HDD alarms:
1. From the menu toolbar, click
2. Select the notification event to configure under Notification Type box.
3. Select
HDD Full
system notifications" on page 30 for more information.
Select
HDD Error
4. Click to save the settings.
Apply

Checking the S.M.A.R.T. information

S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) reports on a
variety of hard drive attributes. It helps ensure that the HDD is functioning
properly at all times while protecting video stored on the hard drive.
To view the S.M.A.R.T. information of a HDD:
1. From the menu toolbar, click
2. Select the
S.M.A.R.T.
3. Select the HDD whose data you want to see. A detail listing of S.M.A.R.T.
information is displayed.
TruVision DVR 12 User Manual
System Settings
window.
Alarm Settings
and check the desired notification method. See "Setting up
and check the desired notification method.
System Settings
tab to display its window.
Chapter 7: Operating instructions
>
Hard Disk.
System Settings > System
> Notification.
>
Hard Disk.
45