Setting The Hdd Property - Interlogix TruVision DVR 12 User Manual

Chapter 7: HDD management
To set the HDD quota:
1. From the menu toolbar, click
2. Click the
Storage mode
3. Under the Mode option, select Quota.
4. Select a camera whose storage capacity you want to change and enter the
values in GB for maximum record capacity and maximum picture capacity.
The maximum storage capacity of the HDD is listed.
5. Click to save the settings.
Apply
6. If you want to copy these values to other cameras, click
cameras. Click OK. Click

Setting the HDD property

You can change the behavior of your HDD by changing its property. It can be set
to read-only or read/write (R/W).
A HDD can be set to read-only to avoid important recorded files from being
overwritten when the HDD becomes full.
To change a HDD status property:
1. From the menu toolbar, click
2. Click the
HDD Information
3. Select the HDD whose property you want to change.
4. Click the icon
Edit
5. Click the desired HDD property for the selected HDD.
6. Click the group number for this HDD.
7. Click to save and exit the window.
Apply
Note: Once set to read-only, the HDD cannot be used to save recorded files
until it is set back to read/write (R/W). If the HDD that is currently being
written to is set to read-only, the data is then recorded to the next HDD. If
there is only one HDD present, setting it to read-only means the DVR cannot
record.
44
System Settings
tab.
to save the settings.
Apply
System Settings
tab.
. The Local HDD Settings window appears.
>
Hard Disk.
and select the
Copy
>
Hard Disk.
TruVision DVR 12 User Manual