Installing The Option Serial Interface Board - Kyocera FS-1900 Service Manual

(9) Installing the option serial interface board

The main board of the printer is equipped with a serial interface connector (YC05) for serial interface
board IB-10E.
CAUTION
Be sure that no foreign object such as metal chips or liquid get inside the
printer during the installation process. Operation of the printer during the
presence of a foreign object may lead to fire or electric shock.
WARNING
Turn the printer's power switch off. Unplug the printer's power cable and
disconnect the printer from the computer.
1. Turn the power switch off.
2. Remove the two screws 1 then remove the main board 2.
3. Remove the two screws 3 then remove the option interface card slot cover 4.
4. Insert the serial interface board 5 to the option interface card slot 6.
5. Fix the serial interface board 5 by two screws 3.
6. Connect the connectors of cable 7 between serial interface board connector 8 and main board
connector (YC05 9).
7. Make sure that the serial interface board has been properly installed by printing out the printer's
status page.
Figure 2-2-14 Installing the option serial interface board IB-10E
9
2-17
4
7
3
6
2
3
1
3
1
8
3
5
FS-1900