Sony DNW-A100 Operation Manual page 88

6-1 Automatic Editing
Starting automatic editing
When you have set the edit points, press the flashing
AUTO EDIT button.
The AUTO EDIT button changes from flashing to
continuously lit, and the automatic editing operation
begins.
At the end of the editing operation, the AUTO EDIT
button goes off.
RECALL button
ENTRY button
OUT button
AUTO EDIT button
PREVIEW/REVIEW button
To change the OUT point after starting
automatic editing operation
After starting the automatic editing operation, to end
the operation before the preset OUT point, hold down
the ENTRY button and press the OUT button.
The position where you pressed the button becomes
the OUT point, and editing ends.
To abandon automatic editing
Press the STOP button.
The automatic editing operation is abandoned. At the
same time, the PREVIEW/REVIEW button and
AUTO EDIT button start flashing, and the state before
the editing was started is restored.
In this case, the IN and OUT points already set are
preserved so that you can carry out a preview or
automatic editing operation again by pressing the
PREVIEW/REVIEW button or AUTO EDIT button.
6-8
Chapter 6 Editing Without Using the Built-in Hard Disk (Two-VTR Editing)
Reviewing the editing results
After carrying out an editing operation, you can carry
out a review, to check the editing results on the
monitor.
To carry out a review, after carrying out the edit, and
before you set any new edit points or make other
settings, press the PREVIEW/REVIEW button.
The PREVIEW/REVIEW button lights, and the review
is carried out.
At the end of the review the PREVIEW/REVIEW
button goes off, and the tape returns to the OUT point.
After automatic editing, to adjust the edit
points and reexecute the edit
Hold down the RECALL button or DELETE button,
and press the ENTRY button to recall the edit points.
After adjusting the edit points, press the AUTO EDIT
button to carry out the edit again.
For details of how to adjust edit points, see Section 6-1-4,
"Modifying and Deleting Edit Points" (page 6-4).