Sony DNW-A100 Operation Manual page 121

If it is not possible to delete the program (e.g.
when the hard disk is busy immediately after
power on)
The following message appears in the time data
display.
In this case, wait until the DISK BUSY indicator
in the lower control panel goes off, then return to
step 2.
4
Press the SET button to carry out the program
deletion.
The indication in the time data display changes as
follows.
During the program deletion
When the program deletion is completed
5
Press the MENU button a number of times, to exit
from the disk file management menu.
The indication in the time data display returns to
the state before executing step 1.
Deleting the program and all files from the
hard disk (DISK PROGRAM and DISK
MASTER) (F5)
Use the following procedure to delete the program and
all files from the hard disk (DISK PROGRAM and
DISK MASTER).
1
Display the disk file management menu, select
item F5, then press the SET button.
The displays shown below appear in the time data
display and on a monitor connected to the
COMPOSITE VIDEO OUTPUT 3 (SUPER)
connector.
Time data display
Monitor
DISK FILE MANAGEMENT
F5:DELETE ALL FILE
2
Holding down the JOG button, turn the search dial
so that the indication in the time data display
changes from "OFF" to "ON".
Displayed while the JOG button is held down.
3
Release the JOG button to confirm the setting.
The indication in the time data display changes as
follows.
*OFF
(Continued)
7-31
Chapter 7 Menu System