Sony DNW-A100 Operation Manual page 113

Item number Item name
809 AUDIO LEVEL METER
DIMMER CONTROL
810 AUDIO EDIT PREVIEW
SWITCHER
a)
813 AUDIO CH3 INPUT
SELECT
(Before Version 2.00)
814 a) AUDIO CH4 INPUT
SELECT
(Before Version 2.00)
815 AUDIO SAMPLING RATE
CONVERTER
(Only when BKNW-105
installed)
a) When using a version 2.00 or later unit, you can turn the MIXING indicator on the upper control panel on and select any
channel as the recording channel.
Item number Item name
911 NO COMPRESSION LINE Specify the "NO COMPRESSION" line (1 line in 1 field) for video input other than
Menu items in the 800s, relating to audio control (Continued)
Settings
Set the brightness of the audio level meters.
0 ... 7: Set in this range. 0 is the brightest, and 7 the dimmest.
Set the output phase for the audio playback signal when any of the ASSEMBLE/
ALL, AUDIO, and AUDIO CH1 to CH4 buttons is lit.
INT : The audio playback signal output phase is the same as the output phase in
the EE mode. Use this setting when editing with a single VTR, or when
previewing while watching the VTR output signal.
EXT: The audio playback signal output phase is the same as the phase of an
input video signal or external reference video signal.
Note
Whichever setting is used, the correct editing results will be obtained. When,
however, you are using an external switcher to switch the audio output signal
from this unit for the purposes of preview, selecting EXT will prevent any muting
or discontinuities in the audio at editing IN and OUT points.
Select the input to digital audio channel 3.
SW : Record the input selected on the upper control panel.
CH1: Record the same signal on channel 3 as on channel 1.
Select the input to digital audio channel 4.
SW : Record the input selected on the upper control panel.
CH2: Record the same signal on channel 4 as on channel 2.
Select whether or not the sampling rate converter operates on AES/EBU input in
CH1-1 to CH-4.
OFF : Does not operate
ON: Operates
Menu items in the 900s, relating to digital processing
Settings
SDDI input.
OFF : No specification.
12H ... 21H: Specify one of lines 12 to 21.
Notes
• The data in the specified line will be recorded and played back without video
data rate compression.
• Data values 0x00 and 0xFF will be converted to 0x01 and 0xFE for playback.
• For the line specified in this item, it is not possible to carry out video adjustment,
chroma adjustment, or other output adjustments.
• When item 726 is set to WIDE, a number of words at the beginning and end of
each line will be subject to horizontal blanking, and will not be played back.
• For playback of a composite signal in jog or variable mode, according to the
setting of item 705, the data will be subject to ESR (edge subcarrier reducer)
processing.
7-23
Chapter 7 Menu System