Sony DNW-A100 Operation Manual page 108

7-3 Extended Menu
Item number Item name
701 SELECTION OF VIDEO/
SYNC DELAY
703 BLANK LINE SELECT
Sub-Item
0 ALL LINE
In 525 mode 12 ... LINE 12 ... LINE
20 20
In 625 mode 9 ... LINE 9 ... LINE 22 Specify blanking for lines 9 to 22.
22
23 LINE 23
704 DECODE Y/C SEP MODE
(Enabled only when the
DNW-A100/A50/A45 is in
525 mode or the DNW-
A100P/A50P/A45P is in
625 mode.)
Sub-Item
When BKDW- 12 ... LINE 12 ... LINE
505 is used
20 20
for DNW-
A100/A50/
21 ... LINE 21 ... LINE
A45
22 22
When BKDW- 9 ... LINE 9 ... LINE
506 is used 22 22
for DNW-
A100P/A50P/
A45P
705 EDGE SUBCARRIER
REDUCER MODE
7-18
Chapter 7 Menu System
Menu items in the 700s, relating to video control
Settings
An EE video signal is output delayed with respect to the video input signal by the
time for video circuit processing. With this item, select whether or not to delay the
sync signal attached to the output video signal by an amount corresponding to the
delay.
SYNC : Delay the sync signal by the corresponding amount before attaching it.
VIDEO: Attach a sync signal with the same timing as the input signal.
Switch blanking on or off for individual lines in the vertical blanking interval. The
Y/C signal and odd/even fields are blanked simultaneously.
Note
For playback of an analog Betacam cassette (Betacam SP, etc.) regardless of the
setting of this item, the chrominance signal is blanked up to line 15.
- - - : Specify the blanking for each line separately.
BLANK: Regardless of the setting of other sub-items, blank all lines which can be
specified in this menu item.
THROU: Regardless of the setting of other sub-items, switch off blanking for all
lines which can be specified in this menu item.
Specify blanking for lines 12 to 20.
BLANK: Carry out blanking.
THROU: Switch off blanking.
BLANK : Carry out blanking.
THROU: Switch off blanking.
Specify blanking for line 23.
HALF : Carry out half-blanking.
THROU: Switch off blanking.
Select the method of processing the input video signal in the vertical blanking
interval, independently for each line.
Make the selection for lines 12 to 20.
BPF: Carry out Y/C separation.
B&W : Treat all as luminance signals.
Make the selection for lines 21 and 22.
BPF: Carry out Y/C separation.
B&W: Treat all as luminance signals.
COMB : Process with an appropriate Y/C separation.
Make the selection for lines 9 to 22.
BPF: Carry out Y/C separation.
B&W : Treat all as luminance signals.
During recording and playback of a composite signal, in the playback circuit the
edge subcarrier reducer (ESR) is automatically switched on or off according to
the VTR operation. When recording a "Non-Standard" signal, for example, if the
color edges are not as good as with a proper signal, the ESR can be forced on.
This item makes this selection.
AUTO : ESR is switched on and off automatically.
ON: ESR operation is forced on.