Sony DNW-A100 Operation Manual page 118

7-4 Disk File Management Menu
To switch from simple edit mode to full edit
mode
Carry out either of the following procedures.
• Using the procedure in the next item, "Converting file
types (F2)", convert the existing files to full edit files.
The setting of item F1 changes to "FULL", and the
FULL EDIT indicator in the lower control panel
lights.
This preserves the existing program and files.
• Using the procedure in the item, "Deleting the
program and all files from the hard disk (DISK
PROGRAM and DISK MASTER) (F5)" (page 7-31),
delete all existing files, then carry out the procedure
in the previous item, "Switching between full edit
mode and simple edit mode (F1)."
To switch from full edit mode to simple edit
mode
The procedure for switching from full edit mode to
simple edit mode depends on whether there are files
and a program present, or files only.
When there are files and a program present, carry out
either of the following procedures.
• Using the procedure in the item, "Deleting the
program from the hard disk (DISK PROGRAM)
(F4)" (page 7-30), delete the program, then carry out
the procedure in the previous item, "Switching
between full edit mode and simple edit mode (F1)."
This preserves the existing files.
• Using the procedure in the item, "Deleting the
program and all files from the hard disk (DISK
PROGRAM and DISK MASTER) (F5)" (page 7-31)
, delete all existing files, then carry out the procedure
in the item, "Switching between full edit mode and
simple edit mode (F1)" (page 7-26).
When there are files present but no program, carry out
either of the following procedures.
• Using the procedure in the next item, "Converting file
types (F2)", convert the existing files to simple edit
files.
The setting of item F1 changes to "SIMPLE", and the
SIMPLE EDIT indicator in the lower control panel
lights.
This preserves the existing program and files.
• Using the procedure in the item, "Deleting the
program and all files from the hard disk (DISK
PROGRAM and DISK MASTER) (F5)" (page 7-31),
delete all existing files, then carry out the procedure
in the item, "Switching between full edit mode and
simple edit mode (F1)" (page 7-26).
7-28
Chapter 7 Menu System
Converting file types (F2)
Use the following procedure to convert the type of
files recorded on the hard disk (full edit files or simple
edit files).
Note that you can check the current file type from the
FULL EDIT and SIMPLE EDIT indicators on the
lower control panel.
1
Display the disk file management menu, select
item F2, then press the SET button.
The displays shown below appear in the time data
display and on a monitor connected to the
COMPOSITE VIDEO OUTPUT 3 (SUPER)
connector.
Time data display
Monitor (for conversion from SIMPLE to FULL)
DISK FILE MANAGEMENT
F2:CONVERT TYPE(S<->F)
*OFF
Convert type
FULL--->SYMPLE
2
Holding down the JOG button, turn the search dial
so that the indication in the time data display
changes from "OFF" to "ON".
Displayed while the JOG button is held down.
3
Release the JOG button to confirm the setting.
The indication in the time data display changes as
follows.