Sony DNW-A100 Operation Manual page 106

7-3 Extended Menu
Menu items in the 600s, relating to the time code generator (Continued)
Item number Item name
602 VITC POSITION SEL-2
603 ID CODE PRESET
604 ID CODE SW
605 TCG REGEN MODE
606 TC OUTPUT SIGNAL IN
REGEN MODE
U-BIT BINARY GROUP
607
FLAG
7-16
Chapter 7 Menu System
Settings
In 525 mode
Select a line to insert the VITC in.
12H ... 18H ... 20H: Select any line from 12 to 20.
Note
You can insert the VITC signal in two places. To insert it in two places, set both
items 601 and 602.
In 625 mode
Select a line to insert the VITC in.
9H ... 21H ... 22H: Select any line from 9 to 22.
Note
You can insert the VITC signal in two places. To insert it in two places, set both
items 601 and 602.
Select whether or not to set the ID code.
OFF : Do not set the ID code.
ON: Set the ID code.
To set the ID code:
1 Set this item to ON.
The HOLD indicator on the lower control panel lights, and the time data display
areas flash.
2 Turn the search dial to select the column, then hold down the SHUTTLE or
JOG button while turning the search dial to change the digit value.
3 When the ID code setting is complete, press the SET button.
This saves the ID code setting, and the setting of this item returns to "OFF".
Select whether or not to record the ID code set using item 603 in the user bits.
OFF : Record the normal data in the user bits.
ON: Record the ID code in the user bits.
Select the signals to be regenerated when the time code generator is in the
regeneration mode (i.e., when the REGEN/PRESET switch in the time code
setting section is set to REGEN, or the unit is in automatic edit mode).
TC&UB: Both the time code and user bit signals are regenerated.
TC: Only the time code signal is regenerated.
UB: Only the user bit signal is regenerated.
Select the signal output from the TIME CODE OUT connector during normal (x1)
speed playback in the following three cases:
• For tape playback when the INT/EXT switch in the time code setting section is
set to INT and the PRESET/REGEN switch is set to REGEN.
• For hard disk playback when the PRESET/REGEN switch in the time code
setting section is set to REGEN.
• For preroll or postroll playback during automatic editing with the tape.
TAPE : During tape playback, the playback time code signal is output without
regeneration (in this case the output video and the time code values output
from the TIME CODE OUT connector do not agree). During disk playback, no
time code signal is output.
REGEN: The playback time code (for disk playback, the playback LTC value) is
output after regeneration.
Select the user bits to be used in the time code generated by the time code
generator.
000 : Character set not specified.
001: 8-bit characters compliant with ISO 646 and ISO 2022.
010: Undefined.
011: Undefined.
100: Undefined.
101: SMPTE 262M page/line multiplex system.
110: Undefined.
111: Undefined.