Sony DNW-A100 Operation Manual page 32

2-2 Connector Panel
4 COMPOSITE VIDEO OUTPUT connectors
(BNC type)
These output analog composite video signals.
When the CHARACTER switch on the subsidiary
control panel is set to ON, the output from connector 3
(SUPER) has superimposed text information such as
time code, menu settings, and alarm messages.
5 COMPONENT VIDEO OUTPUT connectors
(BNC type)
These output analog component video signals (Y/R–Y/
B–Y).
3 Digital input/output section
1 SDDI DIGITAL INPUT connector (DNW-A100/A100P
only)
2 SDI DIGITAL INPUT connectors
DIGITAL INPUT
SDDI (OPTION) SDI
3 SDDI DIGITAL OUTPUT
connectors (DNW-A100/A100P only)
4 SDI DIGITAL OUTPUT connectors
1 SDDI (Serial Digital Data Interface) DIGITAL
INPUT connector (BNC type) (DNW-A100/A100P
only)
Input SDDI format digital video/audio signals. This
connector can only be used when the optional SDDI
input board is installed.
2 SDI (Serial Digital Interface) DIGITAL INPUT
connectors (BNC type)
Input D1 format digital video/audio signals. Of the
two connectors, the upper one is for input, and the
lower one is for a active-through connection.
3 SDDI (Serial Digital Data Interface) DIGITAL
OUTPUT connectors (BNC type) (DNW-A100/
A100P only)
These output SDDI format digital video/audio signals.
4 SDI (Serial Digital Interface) DIGITAL
OUTPUT connectors (BNC type)
These output D1 format digital video/audio signals.
2-24
Chapter 2 Location and Function of Parts
DIGITAL OUTPUT
SDDI SDI
1 1
2
2
4 Time code input/output section and
audio monitor signal output section
1 TIME CODE IN connector
TIME CODE
IN
MONITOR OUTPUT
R
1 TIME CODE IN connector (XLR 3-pin, female)
To record time code from an external device, input a
time code signal from the time code output connector
of the other device.
2 TIME CODE OUT connector (XLR 3-pin, male)
This outputs a time code according to the operating
state of the unit, as follows:
• During playback: the playback time code
By setting extended menu item 606, you can also
output the time code from the internal time code
generator locked to the playback time code..
• During recording: the time code generated by the
internal time code generator or the time code input to
the TIME CODE IN connector.
3 MONITOR OUTPUT connectors (XLR 3-pin,
male)
According to the setting of the AUDIO INPUT /
MONITOR SELECT buttons (Before Version 2.00) or
the AUDIO INPUT/MIXING/MONITOR SELECT
buttons (Version 2.00 or later) on the upper control
panel, two (L and R) audio monitor signals are output.
2 TIME CODE OUT
connector
OUT
L
3 MONITOR OUTPUT
connectors