Removing The Turntable Motor & The Air Tube & Vent Base; Turntable Motor - Whirlpool SPEEDCOOK GH6208 XR Technical Education

REMOVING THE TURNTABLE MOTOR &
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug microwave oven or disconnect
power.
2. Remove the bottom cover (see page 4-2
for the procedure).
3. To remove the turntable motor, remove
the two T10 torx screws and washers.
THE AIR TUBE & VENT BASE
Screw (1 of 2)

Turntable Motor

Door Vent
Wire Tie
Air Tube
Vent Base
4. To remove the air tube & vent base:
a) Pull out on the two clips, and pull the
end of the air tube off the 90° vent
base.
b) Cut the wire tie from around the air
tube (see the left photo), and pull the
end of the air tube out of the door
vent.
c) Turn the 90° vent base to the right
(clockwise) to unlock the four tabs
from the slots in the chassis, and pull
the base off the chassis.
Tab Slot
(1 of 4)
90 ° Vent
Base
Continued on the next page.
4-5
Air Tube
90 ° Vent
Base
Pull Out Clips