Installation Instructions - Whirlpool SPEEDCOOK GH6208 XR Technical Education

CONVERT OVEN TO EXTERNAL
VENTING (WALL OR ROOF
VENTING ONLY)
The oven is set for ventless (recirculating) in-
stallation. For wall or roof venting, changes
must be made to the venting system.
NOTE: Skip this section if you are using
ventless (recirculating) installation. Keep the
damper assembly in case the venting method
is changed, or the oven is reinstalled in an-
other location where wall or roof venting may
be used.
To prepare the oven for wall or roof venting,
the vent deflector (L-shaped metal bar) must
be installed, and the appropriate damper vent
opening must be uncovered.
To Install Vent Deflector:
1. Gently pull the rings and lift vent screen
from the top of the oven.
B
A. Top of oven
B. Vent screen
C. Rings
2. With vent deflector oriented as shown
(wide side down), slide it back and under
the back edge of the vent opening.
A
A. Vent opening
B. Vent deflector

INSTALLATION INSTRUCTIONS

A
C
B
3. When the vent deflector is as far back as
it can easily slide, flip it so that the wide
side is to the back of the oven, and the
narrow side (with holes) is down. The
vent deflector holes should align with the
mounting holes in the oven vent opening,
as shown in inset.
4. Secure vent deflector with 2 mounting
screws (1 on each end).
5. Replace vent screen.
2-3
A B
A. Vent opening
B. Vent deflector
A B
A. Mounting screw
B. Vent deflector