Line Fuse - Whirlpool SPEEDCOOK GH6208 XR Technical Education

6. To remove the relay control board:
a) Lift the right panel and relay control
board and unhook the two side T-tabs,
and pull the right panel and relay con-
trol board forward as far as the wires
will allow.
b) Disconnect all of the wire connectors
from the relay control board plugs.
c) Squeeze the locking tabs on top of the
six standoffs, and pull the relay control
board off the standoffs.
Right
Panel
& Relay
Control
Board
d) Remove the T10 torx screw from the
green ground wire and remove the
relay control board. NOTE: The relay
control board and its connectors and
wire colors are shown on the following
page.
7. To remove the line fuse:
a) Unhook the two side tabs, and pull the
right panel and relay control board for-
ward as far as the wires will allow.
b) Remove the line fuse from the fuse
holder.

Line Fuse

4-8
Relay Control Board
Ground Screw