Concluding Steps - Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual

Hide thumbs Also See for PRIMERGY TX2540 M1:
Table of Contents

Advertisement

System board and components
Ê Connect the intrusion switch cable to the system board connector
"INTRUSION" (1) (see section
Ê Connect the front panel cable to the system board connector
"FRONTPANEL" (2) (see section

14.6.4 Concluding steps

Ê Reconnect all remaining cables to the system board. For a complete cabling
overview, please refer to section
Ê Reinstall all remaining system board components as shown in the related
sections:
– Heat sinks: refer to section
– Memory modules: refer to section
page 267
I
Install all memory modules into their original slots.
– Expansion cards: refer to section
page 267
I
Install all expansion cards into their original slots.
– UFM (if applicable): refer to section
– TPM (if applicable): refer to section
Ê If applicable, reinstall the rear fan as described in section
fan" on page
209.
"Installing the system fan holder" on page 75
Ê
"Reassembling" on page 62
Ê
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
corresponding BIOS Setup Utility reference manual.
"Connecting the server to the mains" on page 72
Ê
"Updating or recovering the system board BIOS and iRMC" on page 85
Ê
Ê Reconnect all external cables.
376
"Cabling plans" on page
"Cabling plans" on page
"Cabling plans" on page
"Installing processor heat sinks" on page 288
Upgrade and Maintenance Manual
"Installing a memory module" on
"Installing a memory module" on
"Installing the UFM" on page 345
"Installing the TPM" on page 352
395).
395).
395.
"Installing the rear
TX2540 M1

Advertisement

Table of Contents
loading

Table of Contents