Minimum Startup Configuration - Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual

Appendix
17.4

Minimum startup configuration

Field Replaceable Units (FRU)
If the server does not start up or other problems occur, it may be necessary to
take the system down to its most basic configuration in order to isolate the
defective component.
The minimum startup configuration consists of the following components and
cables:
Component
System board
1 CPU with CPU heat sink
1 memory module
Front panel module
1 Power supply module
Table 6: Minimum startup configuration - components
Cable
Front panel cable
Power cable
Table 7: Minimum startup configuration - cables
"Shutting down the server" on page 48
Ê
"Disconnecting the server from the mains" on page 48
Ê
Ê Take the system down to its minimum startup configuration.
"Connecting the server to the mains" on page 72
Ê
Ê Connect a keyboard, mouse and display to the server.
Ê Switch on the server as described in section
page 73.
420
Notes and reference
no TPM, UFM or expansion cards installed
installed in socket CPU 1
installed in DIMM slot 1A
installed in PSU bay 1
Notes and reference
Upgrade and Maintenance Manual
"Switching on the server" on
TX2540 M1