Concluding Steps - Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual

Hide thumbs Also See for PRIMERGY TX2540 M1:
Table of Contents

Advertisement

Processors
Ê Remove the desired processor as described in section
processor" on page
Ê Install the new processor as described in section
page
275.
Ê In case of transferring a processor install the protective cover to the
defective system board as described in section
cover" on page

11.4.3 Concluding steps

"Installing processor heat sinks" on page 288
Ê
"Reassembling" on page 62
Ê
"Connecting the server to the mains" on page 72
Ê
I
If the Global Error LED is flashing with the error message "CPU has
been changed" on the display after the system is powered on, please
follow the steps below.
Ê Restart the system and wait until the screen output appears.
Ê Press [F2].
Ê If a password is assigned, enter this password and confirm with
[Enter].
The BIOS setup main menu will be displayed on the screen.
Ê Select "Save Changes and Exit" or "Save Changes and Reset" on
the Save & Exit menu.
Ê Confirm that the Global Error LED is off.
This is only information regarding to the change of the CPU
configuration. There is no technical problem.
"Updating or recovering the system board BIOS and iRMC" on page 85
Ê
applicable)
"Switching on the server" on page 73
Ê
"Enabling SVOM boot watchdog functionality" on page 96
Ê
"Enabling BitLocker functionality" on page 101
Ê
286
280.
283.
Upgrade and Maintenance Manual
"Removing a
"Installing a processor" on
"Installing the protective
(if
TX2540 M1

Advertisement

Table of Contents
loading

Table of Contents