Mercedes-Benz COMAND control panel Operating Instructions Manual page 88

Map operation and settings
86
the COMAND controller and press W to
confirm.
Select Vehicle Position Map
X
W to confirm or, if the crosshair is shown,
press the k back button.
This hides the crosshair.
Centering on the destination
This function requires that a route to a
destination has been calculated.
To show the menu: press W the COMAND
X
controller.
Select Position
X
menu bar by sliding VÆ and turning cVd
the COMAND controller and press W to
confirm.
Select Destination Position Map
X
press W to confirm.
The crosshair is centered on the
destination.
Centering on an intermediate stop
position
This function requires that a route to a
destination has been calculated.
To show the menu: press W the COMAND
X
controller.
Select Position
X
menu bar by sliding VÆ and turning cVd
the COMAND controller and press W to
confirm.
Select Center Map On Stopover
X
press W to confirm.
The crosshair is centered on the
intermediate stop position.
and press
in the navigation system
and
in the navigation system
and
Map display
Setting the map orientation
Map orientation
Current map orientation
:
The following display modes are possible:
0 North orientation (the map view is
R
displayed so that north is always up).
¤ Orientation in direction of travel (the
R
map is displayed so that the direction of
travel is always up; the orange point of the
icon points north).
¤ Bird's-eye view (the map is displayed so
R
that the direction of travel is always up; the
map projection reproduces the curvature
of the earth and the orange point of the icon
points north).
Example display: Bird's-eye view
Current crosshair position
:
Current map orientation
;
To show the menu: press W the COMAND
X
controller.
Select Navi in the main function bar by
X
sliding ZV and turning cVd the COMAND
controller and press W to confirm.