Mercedes-Benz COMAND control panel Operating Instructions Manual page 162

General information
160
Remote control
Overview
To switch the screen on/off
:
To switch the button lighting on/off
;
To select the screen for the remote
=
control
To select a menu or menu item with arrow
?
keys
To confirm the selection or setting with
A
9
To switch sound on/off (for corded
B
headphones)
To adjust the volume (for corded
C
headphones)
To skip, fast-forward/fast-rewind
D
To select a track; direct entry
E
To exit a menu (back)
F
Selecting the screen for the remote
control
You can use the remote control to operate
one of the two rear screens at a time. To do
so, you must switch the remote control to the
desired screen.
To select the left-hand screen: turn
X
thumbwheel = until "L REAR" is
highlighted in the window.
To select the right-hand screen: turn
X
thumbwheel = until "REAR R" is
highlighted in the window.
Switching the screen on/off
If the SmartKey is in position 0 or 1 in the
ignition lock (see the vehicle Operator's
Manual), or the SmartKey is not inserted, the
screens in the rear will switch off after 30
minutes. Before the screens switch off, they
show a message to this effect.
You can switch the screens back on.
However, this will discharge the starter
battery.
Point the remote control at the rear-
X
compartment screen which has been
selected for remote operation.
Press on/off button : on the remote
X
control.
The respective rear screen switches on or
off.
i
You can only switch the screens on using
the remote control if the ignition is
switched on.
Switching the button lighting on/off
Press button ; on the remote control.
X
Depending on the previous status, the
button lighting is switched on or off.
i
If you do not use the remote control for
about 15 seconds, the button lighting
switches off automatically.