Mercedes-Benz COMAND control panel Operating Instructions Manual page 124

Satellite radio
122
Registering satellite radio
Switch on satellite radio mode
X
( page 122).
Y
The satellite radio main menu appears
showing the weather channel. You cannot
select any other stations.
Select Sat Radio
X
and press W to confirm.
Select Service
X
The service information screen appears.
Service information screen
Provider's phone number (SIRIUS XM)
1
SIRIUS XM ID of your satellite receiver
2
Call the phone number of your satellite
X
radio provider shown on the screen.
i
You can also have the satellite service
activated online. To do so, visit the SIRIUS
XM Radio website at
http://www.sirius.com (USA) or
http://www.siriuscanada.com
(Canada).
Once the connection has been established:
Follow the instructions of the service staff.
X
The activation process may take up to ten
minutes. If the activation is completed
successfully, the
appears in the display, followed by the
satellite radio main menu.
i
If registration is not included when
purchasing the system, your credit card
details will be required to activate your
account.
in the lower menu bar
and press W to confirm.
No Service message
If the satellite receiver is not installed or is
not installed correctly, the
Unavailable message will appear.
Switching on satellite radio mode
Notes
You can also use the multifunction steering
wheel to tune in channels or scroll through
lists, e.g. by pressing the =;
9: buttons ( page 21).
Y
Important notes on registration, see
"Registering satellite radio" (
Option 1
Press ó the function button.
X
The No Service message appears after
switching on or if no signal is being
received. Once COMAND receives the
signal, the satellite radio display appears.
The station last selected is played.
i
Repeatedly pressing this function button
switches between the FM, AM, WB
wavebands in that order and then switches
to satellite radio mode. Pressing the button
again takes you back to FM radio mode.
Option 2
Select Audio in the main function bar by
X
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
If satellite radio mode was the last mode
selected, it will now be active.
If another audio mode is switched on, you
can now switch to satellite radio mode in
the audio menu.
Select Audio by sliding ZV the COMAND
X
controller and press W to confirm.
The audio menu appears.
Select Sat Radio and press W to confirm.
X
The No Service message appears when
starting up or if no signal is being received.
Device
page 122).
Y