Mercedes-Benz COMAND control panel Operating Instructions Manual page 61

Current vehicle position
:
Crosshair
;
Details of the crosshair position
=
Map scale selected
?
Display = depends on the settings selected
in "Map information in the display"
( page 87). The current street name can
Y
be shown, provided the digital map contains
the necessary data, or the coordinates of the
crosshair if the geo-coordinate display is
switched on and the GPS signal is strong
enough.
Moving the map and selecting the
destination
To scroll the map: slide XVY, ZVÆ or
X
aVb the COMAND controller.
To set the map scale: as soon as you turn
X
cVd the COMAND controller, the scale bar
appears.
Turn cVd until the desired scale is set.
X
Turning clockwise zooms out from the map;
turning counter-clockwise zooms in.
To select a destination: press W the
X
COMAND controller once or several times.
You will see either the address entry menu
with the destination address or, if COMAND
is unable to assign a unique address, a
selection list.
Destination entry
Select a destination by turning cVd the
X
COMAND controller and press W to
confirm.
If the destination is within the limits of the
digital map, COMAND attempts to assign
the destination to the map.
If the destination can be assigned, you will
see the address entry menu with the
address of the destination. If not, you will
see the Destination From Map
To start route calculation: select
X
and press W to confirm.
Entering an intermediate stop
Introduction
When route guidance is active, you can enter
an intermediate stop. Intermediate stops can
be predefined destinations from the following
categories that COMAND offers for selection:
ATM / CASH MACHINE
R
Hospital
R
Gas Station
R
Parking Lot
R
Restaurant
R
However, you can also enter destinations
other than the predefined ones. To do this
select the menu item Other.
You can use the intermediate stop function to
influence route guidance to the main
destination. When you have reached your
intermediate stop, COMAND automatically
59
entry.
Start
Z