Mercedes-Benz COMAND control panel Operating Instructions Manual page 30

Operating COMAND
28
Entering characters using the number
keypad
Press number key B twice in quick
X
succession to select the letter N.
The character appears at the bottom of the
display when the key is pressed. The first
available letter is highlighted.
You see which characters you can enter with
that key. Each time the key is pressed, the
next character is selected.
Example number key B:
press once = M
R
press twice = N
R
press three times = O
R
Wait until the character display goes out.
X
The entries matching your input are shown
in the list.
Enter E, W, space,
X
keys.
i
The space is entered using number key
9.
Further functions in the list with
character bar
To delete characters: select 2 by
X
sliding VÆ and turning cVd the COMAND
controller and press W to confirm.
or
Press the 2 button next to the
X
COMAND controller.
To delete an entry: select the 2
X
symbol by sliding VÆ and turning cVd the
Y with the corresponding
COMAND controller then press W and hold
until the entire entry is deleted.
or
Press and hold the 2 button next to the
X
COMAND controller until the entire entry is
deleted.
To switch the character set: select
X
B and press W to confirm.
To cancel an entry: select the k
X
symbol in the bottom left of the character
bar and press W to confirm.
or
Press the k back button.
X
The address entry menu appears.
To accept the first list entry: press W and
X
hold the COMAND controller until the
address entry menu appears.
The accepted list entry is shown there.
Calling up the list as a selection list
Select the desired city from the selection list.
If there are several entries for a city or if
several cities of the same name are stored,
then ¬ is highlighted in the character bar.
Press W the COMAND controller.
X
It is also possible to switch the city list to the
selection list at any time during character
input.
Slide W the COMAND controller
X
repeatedly until the city list appears as a
selection list.
or
Select ¬ in the character bar by turning
X
cVd the COMAND controller and press
W to confirm.
Option 2: city list as selection list
COMAND either shows the selection list
automatically or you can call up the selection
list from the list with character bar.