Mercedes-Benz COMAND control panel Operating Instructions Manual page 62

Destination entry
60
recalculates the route to the main
destination.
Entering predefined destinations
To switch on navigation mode: press the
X
g function button.
To show the menu: press W the COMAND
X
controller.
Select Destination
X
system menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
Select Stopover
X
Option 1: no intermediate stop has been
entered yet.
Select a category; see option 2.
X
Option 2: an intermediate stop has
already been entered.
Select Change Stopover
X
confirm.
To select a category: select a category by
X
turning cVd the COMAND controller and
pressing W to confirm.
COMAND first searches in the selected
category for destinations along the route.
If there are no destinations available there,
COMAND searches for destinations within
a radius of up to 60 mi of the vehicle
position.
If COMAND finds destinations, a list
appears on the right-hand side of the
display.
The intermediate stops are listed according
to increasing distance from the current
vehicle position. They are displayed in the
form of a name and their position in relation
to the route and your direction of travel.
i
For intermediate stops that are not
located along the calculated route, the
linear distance is shown.
in the navigation
and press W to confirm.
and press W to
If COMAND does not find any destinations,
you will see a message to this effect.
Confirm OK by pressing W.
X
Select a different category.
X
Select the intermediate stop by turning
X
cVd the COMAND controller and pressing
W to confirm.
The address entry menu appears, showing
the destination address.
To start route calculation: select
X
and press W to confirm.
Entering another destination as an
intermediate stop
To switch on navigation mode: press the
X
g function button.
To show the menu: press W the COMAND
X
controller.
Select Dest. in the navigation system
X
menu bar by turning cVd the COMAND
controller and pressing W to confirm.
Select Stopover and press W to confirm.
X
Select Other and press W to confirm.
X
Select Address Entry,
X
From Last Destinations
Selection Step
Address Entry
X
From Memory
X
Start
From Memory,
or From POIs.
Enter a
destination by
address
( page 51).
Y
Select a
destination from
the destination
memory
( page 57).
Y