Mercedes-Benz COMAND control panel Operating Instructions Manual page 82

Destination memory
80
To show the menu: press W the COMAND
X
controller.
Select Navi by sliding ZV and turning
X
cVd the COMAND controller and press
W to confirm.
Select Read Traffic Messages
X
Automatically and press W to confirm.
Depending on the previous state, switch
the option on O or off ª.
Recalculating the route dynamically
If you have selected
reports affecting the route are taken into
account for route calculation.
If you have selected
After Request and COMAND recalculates
the route, a prompt will appear.
To accept the newly calculated route:
X
press W the COMAND controller.
To continue along the original route:
X
select Reject by turning cVd the
COMAND controller and press W to
confirm.
Destination memory
Home address (My address)
Entering the home address via address
entry
Enter the home address as a destination,
X
e.g. as a city, street and house number
Dynamic Route, traffic
Dynamic Route Only
( page 51). Then, save the home address
Y
without starting route guidance
( page 54).
Y
Adopting an address book entry as a
home address
To switch on navigation mode: press the
X
g function button.
To show the menu: press W the COMAND
X
controller.
Select Dest. in the navigation system
X
menu bar by turning cVd the COMAND
controller and press W to confirm.
Select From Memory and press W to
X
confirm.
You will see the destination memory list
either with the character bar (option 1) or
as a selection list (option 2).
Option 1: destination memory list with
character bar
Slide ZV the COMAND controller
X
repeatedly until the destination memory
list appears as a selection list.
Option 2: destination memory list as
selection list
The My Address entry is listed as the first
entry in the destination memory.
Select My Address by turning cVd the
X
COMAND controller and press W to
confirm.
i
If you have not yet entered any
characters, the My Address entry is