Mercedes-Benz COMAND control panel Operating Instructions Manual page 69

Select Yes when the prompt for starting the
X
navigation system is shown. The window
for starting the navigation system appears
( page 54).
Y
Select Start.
X
or
Select No to store the downloaded
X
destination in the destination memory for
later use.
i
The destination addresses are
downloaded in the same order as they are
sent. If you own several Mercedes-Benz
vehicles equipped with an mbrace
subscriber account, each destination
address can be downloaded by each
vehicle associated with the e-mail address
registered for your mbrace account.
Route guidance
Route guidance
General notes
G WARNING
COMAND calculates the route to the
destination without taking into account the
following, for example:
Traffic lights
R
Stop and right-of-way signs
R
Lane merging
R
Parking or stopping prohibited areas
R
Other road and traffic rules and regulations
R
Narrow bridges
R
COMAND may give incorrect navigation
commands if the data in the digital map does
not correspond with the actual road/ traffic
situation. For example, if the traffic routing
has been changed or the direction of a one-
way road has been reversed.
For this reason, you must always observe
applicable road and traffic rules and
regulations during your journey. Road and
traffic rules and regulations always have
priority over the navigation commands
generated by the system.
Route guidance begins once a route has been
calculated ( page 54).
Y
COMAND guides you to your destination by
means of navigation commands in the form
of audible navigation announcements and
route guidance displays.
The route guidance displays can only be seen
if the display is switched to navigation mode.
If you do not follow the navigation
announcements or if you leave the calculated
route, COMAND automatically calculates a
new route to the destination.
If the digital map contains the corresponding
information, the following applies:
when selecting a route, COMAND tries to
R
avoid roads that only have limited access,
67
Z