Tray And Media Errors; Insert Tray [2] Or Tray [2] Missing - Xerox Phaser 6250 Service Manual

Tray and Media Errors

Insert Tray [2] or Tray [2] Missing

Remove Tray 2 and inspect the tray cavity of the printer to ensure that it is
free of obstructions or debris.
Reinstall the tray.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Paper Size Switch Assembly, PL 3.2.4
Troubleshooting Procedure Table
Steps Actions and Questions
1 Check the following for evidence of fault or
damage:
Paper Size Switch Tray [2], PL 3.2.4
Actuators on the right side of Tray [2]
2 Use service diagnostics to test the Tray [2]
Paper Size Switches. Use the table below
for reference.
Do the switches function correctly?
3
Verify the pertinent voltages on pins
P/J47 – 1 <=> P/J47 – 3
P/J47 – 2 <=> P/J47 – 3
P/J47 – 4 <=> P/J47 – 3
Correspond to the paper size switch
position chart below.
4
Verify the pertinent voltages on pins
P/J42 – 16 <=> P/J42-15
P/J42-17 <=> P/J42-15
P/J42-18 <=> P/J42-15
Correspond to the paper size switch
position chart below.
Error Messages and Codes
Wiring and Plug/Jack Map References
"Paper Tray 2" on page 10-17
Yes
Replace the
parts concerned.
Replace Engine
Control Board,
page 8-107.
Go to Step 4
Replace Engine
Control Board,
page 8-107
No
Go to Step 2.
Go to Step 3.
Replace the
Paper Size
Switch
page 8-26.
Replace the
Motor Driver
Board
page 8-101.
3-55