Door And Cover Errors; Close Front Door - Xerox Phaser 6250 Service Manual

Door and Cover Errors

Close Front Door

Ensure that the front door is free of obstructions and fully closed.
Verify that the interlock switch tab actuator is not broken.
Cycle printer power.
If the problem persists, follow the procedure below
Troubleshooting Reference Table
Applicable Parts
Front Cover, PL 1.1.2
Motor Driver Board, PL 12.1.12
Troubleshooting Procedure Table
Steps Actions and Questions
1
Check the following for evidence of fault
or damage:
2
Use service diagnostics to test the
Interlock Switch.
Does the Interlock Switch function
correctly?
3 Verify the voltage between P/J41-35 <=>
P/J41-22 on the Motor Driver Board is 0
VDC.
Close the Front Cover during the check.
Error Messages and Codes
Wiring and Plug/Jack Map References
"Main Wiring Diagram" on page 10-15
"Drive Section" on page 10-18
Motor Driver Board, PL 12.1.12
Interlock Switch on Motor Driver
Board
Actuator tab on the Front Cover
CAM I/R on the Top Imaging
Unit Cover Acutator I/L, PL
11.1.8
Yes
Replace the parts
concerned.
Replace Engine
Control Board,
page 8-107.
Replace Engine
Control Board,
page 8-107.
No
Go to Step 2.
Go to Step 3.
Replace the Motor
Driver Board,
page 8-101.
3-41