Install Or Lock [Y] [M] [C] [K] Toner Cartridge - Xerox Phaser 6250 Service Manual

Color laser printer
Hide thumbs Also See for Phaser 6250:
Table of Contents

Advertisement

Install or Lock [Y] [M] [C] [K] Toner Cartridge

Ensure that the Toner Cartridges are fully seated and locked into position.
Ensure that all ribbon tape has been removed from the cartridges.
Cycle printer power.
If the problem persists, follow the procedure below
Note
Follow this troubleshooting procedure using the Y, M, C or K Steps as
appropriate for the color indicated by the front panel error message.
Troubleshooting Reference Table
Applicable Parts
Toner Present Switch Actuator,
PL 10.1.22
Toner Present Sensor Bracket,
PL 10.1.6
Troubleshooting Procedure Table
Step
Actions and Questions
1
Use service diagnostic to test the toner
present switch of the problem color.
Does the Toner Present Switch (YMCK)
function normally?
2
Check the following for evidence of fault or
damage, replace the assembly if
defective:
Toner Present Sensor Bracket (YMCK),
PL 10.1.6.
Toner Present Switch Actuator (YMCK),
PL 10.1.22.
3
Check the output of the pertinent color
from the Motor Driver Board P/J51-13PIN
<=> P/J51-14, 15, 16, or 17PIN for 0V DC.
4
Check the output of the pertinent color
from the CRUM Reader Board P/J342-
5PIN <=> P/J342-1, 2, 3, or 4PIN for
0VDC.
3-48
Wiring and Plug/Jack Map References
"Developer Section 1" on page 10-19
"Developer Section 1" on page 10-19
Yes
Replace the Engine
Control Board,
page 8-107.
Complete
Go to Step 7.
Go to Step 6.
Phaser 6250 Color Laser Printer Service Manual
No
Go to Step 2.
Go to Step 3.
Go to Step 4.
Go to Step 5.

Advertisement

Table of Contents
loading

Table of Contents