Out Of Paper; Load Tray [2] [3] [4] With [Size] [Type] - Xerox Phaser 6250 Service Manual

Out of Paper; Load Tray [2] [3] [4] with [size] [type]

Remove Tray [2] [3] [4] and inspect the tray cavity of the printer to ensure
that it is free of obstructions or debris.
Ensure that the tray is loaded with supported media.
Ensure that the media guides are properly adjusted.
Reinstall the tray.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
No Paper Sensor, PL 3.3.4 (Tray
2) PL 14.4.4 or 15.4.4 Trays 3 & 4)
Link Actuator, PL 3.3.6 (Tray 2)
PL 14.4.6 or 15.4.6 Trays 3 & 4)
No Paper Actuator PL 3.3.5 (Tray
2) PL 14.4.5 or 15.4.5 Trays 3 & 4)
Troubleshooting Procedure Table
Steps Actions and Questions
1 Fill Tray.
Does the error occur even if the tray is full?
2 Check the following for evidence of fault or
damage:
No Paper Sensor, PL 3.3.4 (PL 14.4.4 or PL
15.4.4)
No Paper Actuator, PL 3.3.5 (PL 14.4.5 or PL
15.4.5)
3 Use service diagnostics to test the Tray No
Paper Sensor.
Does the sensor function correctly?
4 Does the printer function correctly after replacing
the Engine Control Board?
5
Troubleshoot using the wiring diagram "Paper
Tray 2" on page 10-17, "Paper Tray 3" on
page 10-29 or page 10-33, "Paper Tray 4" on
page 10-30.
Does the printer function correctly after replacing
any defective parts?
3-62
Wiring and Plug/Jack Map References
"Paper Tray 2" on page 10-17, "Paper Tray 3" on
page 10-29, or page 10-33 "Paper Tray 4" on page 10-30
Phaser 6250 Color Laser Printer Service Manual
Yes No
Go to Step [2]. Complete
Replace the Go to Step 3.
parts
concerned.
Replace Engine Go to Step 4.
Control Board,
page 8-107.
Complete Go to Step 5.
Complete Replace the
Engine Control
Board,
page 8-107.