Misfeed At Tray 4: Jam T4 - Xerox Phaser 6250 Service Manual

Misfeed at Tray 4: Jam T4

Try feeding paper from another tray.
Ensure that the paper path is free of obstructions and debris.
Ensure that tray is installed correctly.
Remove, fan, and reload the media in the tray.
Ensure that the media in Tray 3 is a supported type and size.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Paper Pick Roller Kit, PL 14.4.3
Paper Feed Roller Kit, PL 14.1.2
HCF Paper Pick Assembly, PL 14.4.1
Troubleshooting Procedure Table
Steps Actions and Questions
1 Does the printer feed paper correctly from
Tray 2?
2
Does the HCF Motor run when printing one
sheet?
3 Use service diagnostics to test the HCF
Motor.
Does the HCF motor function correctly?
4
Verify the voltage between P/J84-3 <=> P/
J81-1 on the Lower Feeder Circuit Board is
+24 VDC
5
Verify the voltage between P/J81-2 <=> P/
J81-1 on the Lower Feeder Circuit Board HCF
is +24 VDC.
6 Verify the connector between the HCF and
the printer is connected properly and not
damaged.
7 Does the error recur after the HCF Motor has
been replaced with a new one?
Error Messages and Codes
Wiring and Plug/Jack Map References
"Paper Tray 4" on page 10-30
"Paper Feed" on page 10-25
"Drive Section" on page 10-28
Yes
Go to Step 2.
Go to Step 10.
Replace the
Engine Control
Board,
page 8-107.
Go to Step 7.
Replace the
Lower Feeder
Circuit Board,
PL 14.5.1.
Replace the
damaged part.
Go to Step 8.
No
See "Misfeed at
Tray 2 Jam T2"
on page 3-33.
Go to Step 3.
Go to Step 4.
Go to Step 5.
Go to Step 6
Go to Step 7.
Complete
3-39