Tray And Media Errors; Insert Tray [2] Or Tray [2] Missing - Xerox Phaser 6300 Service Manual

Tray and Media Errors

When a tray is pulled out that prevents printing during a print job, an error condition
exists.When a tray is pulled out while no job is printing or that does not prevent
printing during a print job, a warning condition exists.

Insert Tray [2] or Tray [2] Missing

The Tray 2 Paper Size Switch indicates that Tray 2 is not installed.
Applicable Status Codes:
Code 160: Insert Tray 2
Warning: Tray 2 is missing
Initial Actions:
Remove the tray and inspect the tray cavity to ensure that it is free of
obstructions or debris.
Reinstall the tray and cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Paper Size Switch, PL3.2.5
Paper Tray, PL2.1.1
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the following for evidence of fault or
damage:
Tray 2 Paper Size Switch, PL3.2.5
Tray 2 Paper Size Switch
Actuators, PL2.1.10
Paper Tray, PL2.1.1
Is there any damage?
2 Test the Tray 2 Paper Size Switches.
Run the Service Diagnostics Paper Size
Switch test. Use the table on (page 2-7).
Do the switches function correctly?
3-54
Wiring and Plug/Jack References
Paper Size Switch Signals table (page 2-7)
Print Engine Map 4 - P/J Locator (page 10-8)
Print Engine Tray 2 Wiring (page 10-18)
Phaser 6300/6350 Color Laser Printer Service Manual
Yes
Replace any
damaged parts.
Replace the Engine
Control Board
(page 8-104).
No
Go to Step 2.
Go to Step 3.