Misfeed At Tray 3: Jam T3 - Xerox Phaser 6250 Service Manual

Misfeed at Tray 3: Jam T3

Try feeding paper from another tray.
Ensure that the paper path is free of obstructions and debris.
Ensure that tray is installed correctly.
Remove, fan, and reload the media in the tray.
Ensure that the media in Tray 3 is a supported type and size.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Paper Pick Roller Kit, PL 14.4.3
(HCF) or PL 15.4.3 (STF)
Paper Feed Roller Kit, PL 14.1.2
(HCF) or PL 15.1.2 (STF)
HCF Paper Pick Assembly, PL
14.4.1 (HCF) or PL 15.4.1 (STF)
Troubleshooting Procedure Table
Steps Actions and Questions
1 Does the printer feed paper correctly from
Tray 2?
2
Does the lower tray assembly (LTA) (HCF or
STF) Motor run when printing one sheet?
3 Use service diagnostics to test the LTA Motor.
Does the LTA motor function correctly?
4 Verify the voltage between P/J84-3 <=> P/
J81-1 on the Lower Feeder Circuit Board is
+24 VDC
5 Verify the voltage between P/J81-2 <=> P/
J81-1 on the Lower Feeder Circuit Board
(LTA) is +24 VDC.
3-36
Wiring and Plug/Jack Map References
"Paper Tray 3" on page 10-29
"Paper Feed" on page 10-25
"Drive Section" on page 10-28 (HCF) or page 10-32
(STF)
Phaser 6250 Color Laser Printer Service Manual
Yes No
Go to Step[2. See "Misfeed at
Tray 2 Jam T2"
on page 3-33.
Go to Step 9. Go to Step 3.
Replace the Go to Step 4.
Engine Control
Board,
page 8-107.
Go to Step 7. Go to Step 5.
Replace the Go to Step 6
Lower Feeder
Circuit Board,
PL 14.5.1 or PL
15.5.1.