Xerox Phaser 6250 Service Manual page 111

Troubleshooting Procedure Table (Continued)
Steps Action and Questions
6 Use service diagnostics to test the
Registration Clutch.
Close the Interlock Switch during the test.
Does the clutch function correctly?
7 Remove the connector J18.
Is J 18-4 <=> J 18-5 less than 200Ω?
8 Verify the voltage between P 18-4 <=> P
18-2 on the Engine Control Board is
+24 VDC.
Close the Interlock Switch while checking
the voltage.
Error Messages and Codes
Yes
Go to Step 8.
Go to Step 8.
Replace the Chute
Assembly
Registration,
page 8-71.
No
Go to Step 7.
Replace the Chute
Assembly
Registration,
page 8-71.
Replace the
Engine Control
Board,
page 8-107.
3-29