Other Switches - Daewoo KORANDO Service Manual

9V-8 SWITCHES

OTHER SWITCHES

Maintenance and repair
(Tailgate Glass Defogger)
1. Check the defogger
Before checking the electric equipment's, usually disconnect
the battery negative(-) terminal.
1) Check the tailgate defogger after battery is fully charged
by running the engine at idle speed.
2) Check the heated wire voltage at tailgate glass center
position "A" by using circuit tester when the tailgate glass
defogger switch is "ON". If the voltage is approx. 6V, the
system is normal.
3) If the voltage indicates 12V at point "A" , it is considered
that there is a short between "A" and (-) terminal.
4)Find out where the voltage abruptly changes to the 0V by
moving tester bar to the (-) terminal side slightly.
5) If the voltage indicates 0V at point "A", it is considered
that there is a short between "A" and (+) terminal.
6) Find out where the voltage abruptly changes to the 12V
by moving tester bar to the (-) terminal side slightly.
2. Checking the switch
1) Remove the tailgate glass defogger switch wire from
instrument panel.
2) Turn on the switch and carry out the continuity test
Terminal NO.
Switch position
OFF
ON
between terminals.
Notice
: It means the electrical continuity between
terminals.
3. Checking the relay
Remove the tailgate glass defogger relay from the relay
box.
1 4 2 5 6