Toshiba QOSMIO G40 Maintenance Manual page 257

4.5 Memory module
3. Remove the memory module(s) while opening the left and right latches.
Installing the memory module
To install the memory module, confirm that the computer is in boot mode. Then perform the
following procedure (See Figure 4-10 and 4-11).
1. Insert the memory module(s) into the connector on the computer slantwise and press
it to connect firmly.
CAUTION: Be sure to install a memory module to slot A. The computer does not boot
2. Install the memory slot cover and secure it with the screws.
3. When the power of the computer is turned on, the computer checks automatically the
memory size. Confirm that the new memory is detected correctly.
4. If the memory is not detected, check that it is connected correctly.
QOSMIO G40 Maintenance Manual (960-632)
Downloaded from LpManual.com Manuals
Latch
Memory module B
Figure 4-11 Removing the memory module
when a memory module in installed into slot A.
After installing the memory module, confirm that the memory module is
secured with the left and right latches.
Never press hard or bend a memory module.
Latch
Memory module A
[CONFIDENTIAL]
4 Replacement Procedures
4-19