Clean The Print Heads, Do A Test Print - Ricoh J001 Service Manual

1.2.7 CLEAN THE PRINT HEADS, DO A TEST PRINT

To clean all the print heads
1. Press the [Power] key to turn the printer on if the printer is off.
2. Press and hold down the [Cancel] key for at least 3 seconds to make the
[Power] key flash. Then release it.
• The printer cleans all four print heads (Normal Cleaning).
• The cleaning takes about 1.5 min.
To print a Nozzle Check Pattern
1. Press the [Power] key to turn the printer off.
2. Wait for the [Power] key to go off.
3. Press and hold down the [Cancel] key. Then press the [Power] key for at least
3 seconds.
4. Release the keys when the four red LEDs go on. The printer will print the
Nozzle Check Pattern.
5. Check the four ladder patterns of the Nozzle Check Pattern. ( 3.7.4)
J001/J003
CÓPIA NÃO CONTROLADA
[Power]
1
2 [Paper Feed]
3 [Cancel]
1-20
CÓPIA NÃO CONTROLADA
INSTALLATION PROCEDURE
G707I931.BMP
SM