Ink End - Ricoh J001 Service Manual

1. Open the printer driver.
2. Select "Printer Configuration"> "Adjust Color Density"> "Obtain Printer Optimize
Value".
3. Check the Print Quality setting and determine if it is appropriate for the print job.
4. Open the printer driver and do three "Head-Cleanings".
5. Print a Nozzle Check Pattern between each cleaning to check the result.
6. If three "Head-Cleanings" does not solve the problem, use the printer driver to do
one "Head-Flushing".
7. Swap the printer for repair if the "Head-Flushing" does not solve the problem.

Ink End

Ink end alert does not go off
Are the ink cartridges inserted correctly?
The printer cannot detect an ink cartridge if it is not inserted completely.
Instructions
1. Check the operation panel messages and the printer driver to determine if
another ink cartridge needs to be replaced.
2. Remove each ink cartridge and insert it again.
3. Make sure each ink cartridge is inserted completely.
4. Cycle the printer off/on.
5. More than one cartridge may be out of ink.
6. If these procedures do not solve the problem, swap the printer for repair.
Ink end alert occurs too early
A. Is the ink alert for C (Cyan) ink?
Compared with other colors, Cyan runs out sooner because it is most often used.
B. Do your print jobs contain large areas of color coverage?
Print jobs with large color areas (bar graphs, pie charts, large color photos, etc.) will
consume ink much faster.
C. Are the ink cartridges starter cartridges provided with the printer?
The starter cartridges provided with the printer contain must less ink than the medium and
large size cartridges that must be purchased.
D. Was the printer power cord disconnected while the printer was initializing?
If the printer is interrupted during initialization, the process will start again from the beginning
the next time the printer is turned on.
J007/J010/J011
CÓPIA NÃO CONTROLADA
18
CÓPIA NÃO CONTROLADA
Call Center Manual