End Fence (Length Adjuster - Tray 1) - Ricoh J001 Service Manual

User Replacement Guide
End Fence (Length Adjuster – Tray 1)
First, always switch the printer off and disconnect the power cord from the power
source. Then disconnect all other cables (USB, etc.)
1. Raise the output tray.
2. Pull out the paper tray [1] until it stops.
3. Remove all the paper from the paper tray.
4. On both sides of the tray, pull out the lock pawls [2] and [3] to the unlock position
then pull out the extension tray so you can see the end fence.
5. Pinch the leaf of the end fence [4] to remove it.
6. Attach the new end fence.
7. Load the paper tray with paper.
8. Pinch the leaf of the end fence to release it, move it to the bottom of the stack and
release it so the bottom fence locks.
9. Reset the locks [2] and [3] of the extension tray for the size of the paper.
10. Push the paper tray into the printer.
11. Lower the output tray.
Call Center Manual
CÓPIA NÃO CONTROLADA
37
CÓPIA NÃO CONTROLADA
J007/J010/J011