After Cleaning The Maintenance Unit - Ricoh J001 Service Manual

After Cleaning the Maintenance unit

1. Do these before you reinstall the maintenance unit:
• Turn the drive gear of the maintenance motor to the right.
• Lower the suction cap and the wiper blade. Make sure they are secure in
the down position.
• Make sure the triangle marks on the sides of the maintenance unit match.
Do this if the tips of the white and black triangle marks [A] are not aligned:
• Insert the tip of a flat head screwdriver [B.] Then slowly rotate it clockwise
until the marks are aligned.
[A]
After you reassemble the printer:
1. Clean all the print heads.
• Make sure the printer is on.
• Press and hold the [Cancel] key for 3 sec.
2. Print a Nozzle Check Pattern to confirm that the printer is operating correctly.
• Switch the machine off.
• Press and hold down the [Power] key and [Cancel] keys together for about
3 seconds. Then release them when the ink level LEDs show red.
• Check the test pattern. Do the procedure again if you see any bare patches
in the pattern. Do this until the pattern is perfect. For more, see section "4.
Troubleshooting".
SM
CÓPIA NÃO CONTROLADA
[B]
2-7
CÓPIA NÃO CONTROLADA
CLEANING PROCEDURES
G707P909.BMP
J001/J003