Component Removal
3.4.8 VERTICAL ENCODER SENSOR
Work carefully to avoid bending or scratching the edge of the vertical encoder
sensor wheel.
1.
Unfasten the vertical encoder PCB by removing screws [1], [2] ( x2).
2.
Disconnect and remove the vertical encoder sensor board and sensor (
3.4.9 VERTICAL ENCODER WHEEL
1.
Remove the spring [1] to release tension on the feed belt ( x1).
2.
Remove the flexible plastic clamp [2] from the tip of the shaft.
J007/J010/J011
CÓPIA NÃO CONTROLADA
3-26
CÓPIA NÃO CONTROLADA
x1)
SM