Bit Switches; Changing Bit Switch Settings - Ricoh J001 Service Manual

Rev. 09/2008
Display Count: Detections of Air Present Before Maintenance
Cleanings
7527 PMT CNT:A:T1
7528 PMT CNT:A:T2
7529 PMT CNT:A:T3
7530 PMT CNT:A:T4
7531 PMT CNT:A:T5
7532 PMT CNT:A:T6
Use this SP to display the number of times air was detected during maintenance
cleaning of the right ink suction vent.

5.3 BIT SWITCHES

Soft bit switches are used to do some basic function settings that determine how the
printer operates. This section describes the functions of these bit switches.

5.3.1 CHANGING BIT SWITCH SETTINGS

1. Push and hold down
2. Push [#Enter].
3. Select "Engine Mainte."
4. When you see "SP No. 1000", select "5301" then push [#Enter].
5. When you see "ENGINE SW" push [#Enter].
ENG SW #1 00001000
bit0 _
Reading from left to right, the digits represents Bit 7 to 0.
"1" switches a bit ON and "0" sets a bit OFF.
The second line of the display contains the cursor. This tells you which bit is
currently active for selection.
Push [Escape] at any time if you want to return to the previous level.
6. Push or to position the cursor under the digit of the bit switch that you
want to change.
7. Push or to display "1" or "0".
8. Push [#Enter] to enable the setting.
9. Push [Escape] until the display returns to "ENGINE MAINTE."
10. Select "3. END" and press [#Enter] to leave the SP mode.
SM
CÓPIA NÃO CONTROLADA
Print Head Tank 1
Print Head Tank 2
Print Head Tank 3
Print Head Tank 4
Print Head Tank 5
Print Head Tank 6
and for 3 sec. then release to enter the SP mode.
5-37
CÓPIA NÃO CONTROLADA
Bit Switches
J007/J010/J011