Install Printer Driver: Usb Connection - Ricoh J001 Service Manual

1.2.8 INSTALL PRINTER DRIVER: USB CONNECTION

The printer driver and the USB driver are located on the installer CD-ROM provided
with the printer.
Important:
• You cannot use the USB cable to connect the printer and PC if you use Windows
95 or Windows NT 4.0. You must use a network connection.
• You can only use the USB cable with Windows 98, Windows Me, Windows 2000,
Windows XP, or Windows Server 2003.
• You must use USB 1.1 if you use Windows 98 or Windows Me. The printer is set
for "Auto Detection" by default. In this mode the printer can use either USB 1.1 or
USB 2.0.
1. Remove the paper seal from the USB port of the printer.
2. Put the installer CD-ROM in the CD-ROM drive of the computer.
3. Follow the instructions on the screen to install the printer driver and the USB
driver.
NOTE: Do not connect the USB cable to the printer until you are instructed to
do so.
To connect the printer to the PC with the USB cable
1. Put the square connector of the USB cable [A] into the connection point on the
back of the printer.
2. Connect the flat connector of the USB cable into the PC.
SM
CÓPIA NÃO CONTROLADA
1-21
CÓPIA NÃO CONTROLADA
INSTALLATION PROCEDURE
[A]
G707I932.BMP
J001/J003