Canon iR1200 Series Service Manual page 386

Chapter 14
##672 [TX]
Remedy:
Cause:
Remedy:
##673 [RX]
Cause:
Remedy:
Cause:
Remedy:
##674 [TX]
Cause:
Remedy:
Cause:
14-30
In V.34 transmission, the procedure fails to move from
phase 2 to phase 3 and later, causing a T1 time-over
condition
(1) Increase the transmission level so that the other party may
receive the signal correctly.
(2) Prohibit the V8./V.34 procedure.
In phase 2, the signal from the other party cannot be received
correctly.
(1) Ask the operator of the other party to increase the transmission
level so that the signal may be received correctly.
(2) Prohibit the V.8/V.34 procedure.
T-14-61
In V.34 reception, the procedure fails to move from
phase 2 to
phase 3 and later, causing a T1 time-over condition
In phase 2, the other party cannot receive the signal correctly, and
disconnect the line.
(1) Increase the transmission level so that the other party may
receive the signal correctly.
(2) Prohibit the V.8/V.34 procedure.
In phase 2, the signal from the other party cannot be received
correctly.
(1) Ask the operator of the other party to increase the transmission
level so that the signal may be received correctly.
(2) Prohibit the V.8/V.34 procedure.
T-14-62
In V.34 transmission, the procedure fails to move from
phase 3 or phase 4 to a control channel or later, causing
a T1 time-over condition
In phase 3 or phase 4, the other party cannot receive the signal
correctly, and disconnect the line.
(1) Increase the transmission level so that the other party may
receive the signal correctly.
(2) Prohibit the V.8/V.34 procedure.
In phase 3 or phase 4, the signal from the other party cannot be
received correctly.