Canon iR1200 Series Service Manual page 369

#018 [TX] Auto dialing transmission error
Remedy: Start a call once again.
Cause: The other party is not connected to the line, or is not turned on so that
the transmission did not arrive.
Remedy: Ask the operator of the other party to find out the cause.
Cause: The other party is not a facsimile machine.
Remedy: Check the number of the other party, and start a call once again.
Cause: The other party ran out of paper so that the line was disconnected during
the preprocedure.
Remedy: Ask the operator of the other machine to set paper.
Cause: The machine was disconnected from the line using an unidentified
reason code.
Remedy: 1. Wait for a while, and start a call once again.
2. Check to make sure that the other party is tuned on.
Cause: 1. The other party did not respond.
2. The other party is out of order.
3. The other party is out of use for some reason.
4. The exchange is congested.
5. There is no line/channel that is available at present.
6. The requested line/channel cannot be used on the side of the other
party.
7. Calls crashed.
8. Communication is not possible at present by reason of terminal
management.
Remedy: Ask the operator of the other party to find out the cause.
#021 [RX] The other party has rejected the machine during polling
reception
Cause: When starting a call, a subaddress, or a subaddress and a password, was
not specified.
Remedy: Specify a subaddress, or a subaddress and a password, when starting a
call.
T-14-16
Chapter 14
14-13