Canon iR1200 Series Service Manual page 384

Chapter 14
##286 [TX]
Cause:
Remedy:
##287 [TX]
Cause:
Remedy:
##288 [TX]
Cause:
Remedy:
##289 [TX]
Cause:
Remedy:
##290 [TX]
Cause:
Remedy:
14-28
T-14-53
DCN has been received after transmitting EOM
The Stop button was pressed during a communication.
Transmit once again.
T-14-54
DCN has been received after transmitting MPS
The Stop button was pressed during a communication.
Transmit once again.
T-14-55
After transmitting EOP, a signal other than PIN, PIP,
MCF, RTP, or RTN was received
The procedure signal has a fault.
Record the protocol on a DAT or MD, and have it analyzed by the
local Canon office and/or Technical Center.
T-14-56
After transmitting EOM, a signal other than PIN, PIP,
MCF, RTP, or RTN was received
The procedure signal has a fault.
Record the protocol on a DAT or MD, and have it analyzed by the
local Canon office and/or Technical Center.
T-14-57
After transmitting MPS, a signal other than PIN, PIP,
MCF, RTP, or RTN was received
The procedure signal has a fault.
Record the protocol on a DAT or MD, and have it analyzed by the
local Canon office and/or Technical Center.