Ricoh SP 4510 DN User Manual page 87

Message
"Command Error."
"Compressed Data Error"
"Duplex cancelled."
"Error occured. Prntd/Cncld."
"Excd Prt Vol Use max count."
"Excd Prt Vol Use max count."
"File System Error."
"File System Full."
Cause
An RPCS command error
occurred.
The printer detected corrupt
compressed data.
Duplex printing was canceled.
An error occurred during
printing, but it was ignored.
Printing was canceled because
the print maximum number was
reached.
Maximum number of user codes
that can be registered has been
reached.
PDF direct printing could not be
performed because the file
system could not be obtained.
The PDF file cannot be printed
because the capacity of the file
system is full.
When Messages Are Displayed
Solution
Check that the communication
between a device and the
printer is working correctly.
Check that the program you
used to compress the data is
functioning correctly.
Change the setting for "Duplex
Tray" in [Paper Input] to enable
duplex printing for the paper
tray.
Check the print settings.
Contact your user administrator.
Delete unnecessary user codes.
Turn the printer off, and then
turn it on again. If the message
appears again, contact your
service representative.
Delete all unnecessary files from
the hard disk, or decrease the
file size sent to the printer.
85