Ricoh SP 4510 DN User Manual page 76

3. Troubleshooting
Message
"@Remote Cert. update failed"
"Cannot connect=>Comm.Serv.
Check proxy user/password."
"Cannot connect with DHCP server.
(101/201)"
"Cannot connect with NetWare print
server. (107/207)"
"Cannot connect with NetWare
server.(106/206)"
"Cannot print."
"Change (Tray name) to the following
settings:"
"Check network settings.(103/203)"
"Classification Code Error"
74
Cause
Updating the @Remote
certificate failed.
The proxy user name or
password is incorrect.
An IP address cannot be
obtained from the DHCP
server.
No connection with the
NetWare print server is
available.
No connection with the
NetWare print server is
available.
The printer cannot print the
sent data.
The size of the paper in the
tray does not match the
paper size specified in the
printer driver.
The IP address setting is
incorrect.
A classification code is not
specified for the print job.
Solution
Turn the printer off, and then
turn it on again. If the
problem persists, contact
your sales or service
representative.
Check the proxy server
settings, and then change the
user name and/or password
if they are incorrect.
Contact your network
administrator.
Contact your network
administrator.
Contact your network
administrator.
Check that the file you want
to print is a supported file
type.
Check the misfeeds and ask
your network administrator
for help.
Select a tray containing
paper that is the same size as
the specified paper size.
Check the IP address, subnet
mask, and gateway address.
Enter a classification code
using the printer properties
and print the document
again.